NACMA Annual Workshop and Conference
November 2-4, 2011
Aerospace Technology Center, Montreal, Canada |
|
You are cordially invited to participate in the 2011 North
American Coordinate Metrology Association (NACMA)* annual
workshop on November 2, 3, & 4 in Montreal, Canada. We are
very pleased to announce that Aerospace Technology Center (CTA) will be our host
for the event.
The event is being hosted by:
CTA – Centre technologique en aérospatiale
5555, place de la Savane,
St-Hubert (Qc) Canada J3Y 8Y9
www.aerospatiale.org <http://www.aerospatiale.org/> |
|
|
Directions to CTA |
|
|
|
|
2011 Workshops and Conferences - Event Hall Information |
|
Total exhibitor spaces available are 13 so only the first 13
sponsors with exhibitor level benefits will be allowed space.
The NACMA workshops and conference will be held in the new
expansion hanger at CTA and the area the
exhibitors will be set up is fabulous. The exhibitor space is
along the perimeter of a room. Each exhibitor will have
approximately 9 linear feet of wall space. Exhibits should
protrude out no more than 6 feet from the wall. A 2’ x 6’
covered table with chair will be made available. |
|
|
Electrical connections will be limited to 115 volts up to 15
Amps. Exhibitors must bring an extension cord (50’ recommended)
and power strip. All portable cords must be the three (3) wire
grounded type per the National Electrical Code. The NEC requires
that all exposed non-current carrying parts of equipment, which
are liable to be energized, shall be grounded. Portable cords
must be rated for the current they are carrying. Cords made of
lamp cord (zip cord) are not permitted.
Setup of all exhibitor areas “with equipment” must be complete
on November 1, 2011. Access to the building will be available
only between 1pm and 4pm unless other arrangements are made.
Exhibitors with no equipment can get set up on the morning of
November 2nd but must be set up prior to 8:00 am.
All exhibitors must schedule their drop off time in advance
with:
Stéphane Carpentier
Directeur Innovation & développement / Manager Innovation &
Development
Tél. /Tel.: (450) 678-2001 p./ext.: 4553
e-mail:
stephane.carpentier@college-em.qc.ca |
|
For additional questions contact:
Edward Yaris, Registration—NACMA
email:
ed.yaris@gdt-consultants.com
Phone: (716) 535-0966 |
|
Note:
Exhibitors need to provide their contact name
(person who is dropping off the equipment), Company/Vendor name
& a cell phone number where they can be reached. |
|